Note: You are seeing this text-only version of our site
because you are using an older browser that is not standards-compliant.
How to upgrade to a FREE standards-compliant browser.
Some Netscape 7 and Mozilla users may see this warning in error.
to fix the problem.
Back to Company
The module can be used in CompactLogix L1 processors or Distributed 1734 Point I/O systems; Configured as a Master or Slave.
Add-on Instruction creates UDTs, providing logical definitions for I/O status and control data; Diagnostic data available in RSLogix 5000/Studio 5000 controller tags, allowing decisions to be based on node health; Configuration backed up in the CompactLogix project (ACD file); Serial port can be enabled or disabled through ladder logic; Supports up to 1,000 words of data, up to 30 Modbus Commands, and up to 35 words per command; Suitable for SCADA and field device interface applications
Configuration Environment RSLogix 5000/Studio 5000; I/O Size User selectable 16, 48, or 70 bytes; Baud Rate: 110 to 38.4K baud; Stop Bits: 1 or 2; Data Size: 7 or 8 bits; Parity: None, Even, Odd; Modbus Modes RTU mode (binary) with CRC-16, ASCII mode with LRC error checking; Node Address 1 to 247
Copyright © 2005-2018 Modbus Organization, Inc.
PO Box 628 Hopkinton, MA 01748. All rights reserved.
By using Modbus.org, you accept the terms of our visitor